GHQ Models Forums

i recently bought the Nebelwerfer and the PaK40 guns, both come with the Sd11 prime mover. the package also included tarp covers for the prime mover, but i can't for the life of me figure out how they are supposed to attach.

looking at the pictures for the 7.62cm PAK36 and one of the other towed artillery (can't remember which) that include the Sd.11 that show the mover in the picture, they don't have tarps on them.

just an extra piece then?

I have many of those vaunted prime movers with the tarp. I'm very glad they gave us the option to have the tarp on or off. But what I do to fit them with the tarp in place is to take an exacto blade (I use a flat, chisle shaped blade) and carefully remove the molded on folded down tarp. You may also have to file down the drivers' helmets too. Once you've done this it fits perfectly in place.

It takes a steady hand!

Chris

ah, that makes sense. i wondered if it was going to take "surgery". thanks for clearing it up. since i have 4 i might do 2 tarped and 2 tarpless.

thanks!

I have been scratching my head over this for about six months now. I was hoping there was a less obvious solution...