GHQ Models Forums

This might be fun ... or not. We'll have to see.

I just had this idea, why not show off where you work on your Micro Armor. Workbench, garage, basement, a desk in your bedroom, the kitchen table, whatever.

I'll start off....

A little over a week ago on my personal MicroArmor blog I posted a picture of my workbench and I titled the post "Before". The workbench was such a mess I could not get any work done. Well today I posted an update photo that is far less embarrassing. I'm not done yet with the cleaning and organizing, but it's getting a lot better. The area covered in this photo is pretty much done, there are areas to the left and right out of the frame that are still a disaster.

To see the more embarrassing "Before" photo (or this one full size), go to http://allensmicroarmor.com/

This is my painting area for figures/microarmour etc. I have a garage for all the terrain making and painting and also a bit of woodworking.

My main painting desk is a writing desk and I can close it up and it looks tidy, and no little fingers get into it!



The drawers store figures, tools and paints


No microarmour in sight when I took this


I'd like to say it is normally tidier but this is typical.

Best part of your post....

6mmwargaming wrote: I'd like to say it is normally tidier but this is typical.

My bench gets cleaned off about once a year. It looks amazing now,,, but it wont last.

Ok here is my mess ... I mean workbench in the basement. All the minis to the right are awaiting decals and crew members, the ones to the left are being painted... I hate painting the infantry so those have been sitting there a long time.




Then on an adjacent table is where I do my resin molds (and sometimes clean my rifles).

It's an old photo and the desk is filled mostly with 6mm buildings...

I posted pics on FB
https://www.facebook.com/chrisswim2
It is messy.

Here is where I paint my GHQ stuff:



All the paints I use are those tubes of oils shown in the picture.